;-----------------------------------------------------------------------------\ ; ADCP Command File for use with VmDas software. ; ; ADCP type: 150 Khz Ocean Surveyor ; Setup name: default ; Setup type: High resolution, short range profile(broadband) ; ; NOTE: Any line beginning with a semicolon in the first ; column is treated as a comment and is ignored by ; the VmDas software. ; ; NOTE: This file is best viewed with a fixed-point font (e.g. courier). ; Modified Last: 21 february 2012 ;----------------------------------------------------------------------------/ ; Restore factory default settings in the ADCP cr1 ; set the data collection baud rate to 38400 bps, ; no parity, one stop bit, 8 data bits ; NOTE: VmDas sends baud rate change command after all other commands in ; this file, so that it is not made permanent by a CK command. cb611 ; Set for broadband single-ping profile mode (WP), 60 cells (WN) 4 meter bins (WS), ; 6 meters blanking distance (WF), 390 cm/s ambiguity vel (WV) NP0 WP00001 WN060 WS400 WF0600 WV390 ; Enable single-ping bottom track (BP), ; Set maximum bottom search depth to 600 meters (BX) BP001 BX06000 ; output velocity, correlation, echo intensity, percent good WD111100000 ; 1 seconds between bottom and water pings TP000100 ; Two seconds between ensembles ; Since VmDas uses manual pinging, TE is ignored by the ADCP. ; You must set the time between ensemble in the VmDas Communication options TE00000200 ; Set to calculate speed-of-sound, no depth sensor, external synchro heading ; sensor, no pitch or roll being used, no salinity sensor, use internal transducer ; temperature sensor EZ1020001 ; Output beam data (rotations are done in software) EX00000 ; Set transducer misalignment (hundredths of degrees) to 45°+2.19° of misalignement EA04719 ; Set transducer depth (decimeters) ED00028 ; Set Salinity keep at 35ppt for spacial localisation of the depth cells (ppt) ES35 ; save this setup to non-volatile memory in the ADCP CK