;-----------------------------------------------------------------------------\
; ADCP Command File for use with VmDas software.
; 
; ADCP type:     75 Khz Ocean Surveyor
; Setup name:    default
; Setup type:    High resolution, short range profile(broadband)
; 
; NOTE:  Any line beginning with a semicolon in the first 
;        column is treated as a comment and is ignored by 
;        the VmDas software.
;
; NOTE:  This file is best viewed with a fixed-point font (e.g. courier).
; Modified Last: 9 April2018
;----------------------------------------------------------------------------/

; Restore factory default settings in the ADCP
cr1

; set the data collection baud rate to 38400 bps, 
; no parity, one stop bit, 8 data bits
; NOTE:  VmDas sends baud rate change command after all other commands in 
; this file, so that it is not made permanent by a CK command.
cb611

; Set for no narrowband ping (NP), broadband single-ping profile mode (WP), eighty (WN) 8 meter bins (WS), 
; 8 meter blanking distance (WF), 390 cm/s ambiguity vel (WV)
NP0
WP001
WN080
WS0800
WF0800
WV390

; Disable single-ping bottom track (BP), 
BP0

; output velocity, correlation, echo intensity, percent good
WD111100000

; One and a half seconds between pings
TP000150

; Three seconds between ensembles
; Since VmDas uses manual pinging, TE is ignored by the ADCP.
; You must set the time between ensemble in the VmDas Communication options
TE00000300

; Set to calculate speed-of-sound, no depth sensor, external synchro heading 
; sensor, no pitch or roll being used, no salinity sensor, use internal transducer 
; temperature sensor, no up/down orientation needed
EZ1020001

; Output beam data (rotations are done in software)
EX00000

; Set transducer misalignment (hundredths of degrees)
EA04672

; Set transducer depth (decimeters)
ED00020

; Set Salinity (ppt)
ES37

; save this setup to non-volatile memory in the ADCP
CK